Blackberry Tour 9630 Take Apart Instructional Repair Guide
June 4, 2018 | 0 Comments
This video guide shows how to disassemble the Blackberry Tour 9630 cell phone quickly and safely. This guide has been designed and put together by the RepairsUniverse team.
This guide will help you to install the following Blackberry Tour 9630 parts:
Tools Required:
Blackberry Tour 9630 LCD Screen Take apart repair guide:
Blackberry Tour 9630 LCD & Touch Screen Digitizer Replacement Summary:
Using this summary in correlation with the video will insure proper instructions are given and a safe repair is made.
- Remove the back cover of the phone also the battery and memory card. Turn the phone over and get a safe pry tool. Using the pry tool, get between the LCD and the top plastic cover to pry the plastic cover off.
- Underneath the cover there are two Torx T6 screws which need to be removed with a Torx T6 screwdriver. Turn the phone over and remove four more T6 screws which are located near the middle and bottom part of the phone.
- Remove the back casing of the phone to get access to the motherboard. Gently remove the pop ribbon cable on the bottom left corner using the safe pry tool.
- Release the antenna cable in the same way as the pop ribbon connection. Release the 4 clips which are located near the middle and bottom part of the phone.
- Ease the phone cover off. Ease the motherboard up but be careful as it is still connected by some flex ribbon cables underneath.
- Using a safe pry tool, pry off the pop connector underneath the motherboard to release the LCD ribbon cables. Turn the phone over and gently pry the LCD screen using the safe pry tool.
This is a video guide to replacing the loud speaker on your Blackberry Tour 9630. Repair your damaged or faulty loud speaker quickly and safely using this repair guide, designed by the RepairsUniverse team. Below the speaker replacement video is a disassembly guide for the Tour 9630 to get access to the housing and speaker.
This guide will help you to install the following Blackberry Tour 9630 parts:
Tools Required:
Optional Tools:
- Small Flathead Screwdriver
- Adhesive Strips - May be required for certain speakers.
Blackberry Tour 9630 Loud Speaker Replacement guide:
Note: Some speakers may need to be raised, using adhesive, to give full contact with the connectors. You may attempt to re-use the previous adhesive from an old speaker, but fresh adhesive is recommended.
Blackberry Tour 9630 Disassembly guide:
Following this video will give you access to the housing and loud speaker.
Blackberry Tour 9630 Loud Speaker Replacement Summary:
Using this summary in correlation with the video will insure proper instructions are given and a safe repair is made.
- Remove the back cover of the phone also the battery and memory card. Turn the phone over and get a safe pry tool. Using the pry tool, get between the LCD and the top plastic cover to pry the plastic cover off.
- Underneath the cover there are two Torx T6 screws which need to be removed with a Torx T6 screwdriver. Turn the phone over and remove four more T6 screws which are located near the middle and bottom part of the phone.
- Remove the back casing of the phone to get access to the housing and loud speaker. Remove old speaker and replace with new speaker. Use, or reuse, adhesive to hold the speaker in place and give it full contact with the connectors..
Notice:
Repairs Universe's guides are for informational purposes only. Please click here for details.
Learn about restrictions on reproduction and re-use of Repairs Universe's repair/take-apart/installation guides, and about creating hyperlinks to our guides.
