Shopping Cart
Free Shipping On USA Orders Over $40

Repair Guides

HTC T-Mobile MyTouch 4G Take Apart Repair Guide

June 4, 2018 | 0 Comments

HTC T-Mobile MyTouch 4G Take Apart Repair Guide

This is the HTC T-Mobile MyTouch 4G video repair guide. Our video has been put together by the RepairsUniverse team and will walk you through the steps of disassembling your MyTouch 4G. The guide is aimed at LCD and touch screen digitizer replacement, but other internal parts may be repaired or replaced. This guide is in a step by step format and can easily be followed for a quick and safe repair.

This guide will help your replace the following parts on your HTC MyTouch 4G:

Tools:

HTC MyTouch 4G Screen Repair Video Guide:

We recommend watching the below video from start to finish before starting the repair, and then pausing / rewinding and reviewing when needed.

Reverse the instructions above to reassemble your phone.

Applying Adhesive to the Touch Screen Digitizer:

HTC MyTouch 4G Screen Repair Summary:

This is a written summary of the repair guide. Following this guide in correlation with the video will insure proper instructions are given.

  • The first step is to remove the back battery cover, the battery, sim card, and memory card. Now remove the two torx 5 screws from the back housing and the small phillips screw located below the sim card holder. You can now use a safe pry tool to release the clips from the outside edges of the frame and remove it.
  • The next step will be to remove the four torx 5 screws surrounding the outside of the back housing. Remove the bottom cover using a safe pry tool. Release the 3 button flex cables, gently use a flat head screwdriver or a safe pry tool. Use a safe pry tool to release the clips on the outside of the back housing. Remove the back housing (frame).
  • Release the power button flex cable using a flat head screwdriver or similar. Use a safe pry tool to release the two pop connectors on the motherboard. Now you can release the vibrate motor and slowly ease the motherboard out, releasing the clips with a safe open pry tool. Be aware that there will still be one flex cable connected to the motherboard underneath it. Lift on the side of the alligator (jaw) clip to release the cable and carefully remove it. The motherboard is now out, and can be put back to the side.
  • Using a heat gun or hair dryer, warm the adhesive under the front of the screen. Use a safe pry tool and lift the front touch screen digitizer and place it above the phone, careful as it is still held in by a flex cable. Heat the back of the LCD screen to loosen the adhesive. Remove the LCD screen from the front of the phone. Ease the touch screen flex cable through the frame. You are now able to replace either the LCD screen or the touch screen glass digitizer.

Notice:

Repairs Universe's guides are for informational purposes only. Please click here for details.

Learn about restrictions on reproduction and re-use of Repairs Universe's repair/take-apart/installation guides, and about creating hyperlinks to our guides.

htc htc-t-mobile-mytouch-4g
leave a comment
Your email address will not be published. Required fields are marked *